Honeywell 1CPSA3

Cable Pull Switch Pull Ring Manual Reset 600V AC 250V DC 10A

Switch Safety Interlock N.O./N.C. 3PST/SPST Eyelet Pull 600VAC Screw Mount Conduit 1000000Cycles

CABLE PULL SAFETY SWITCH, MAINTD, 3NC/1NO DIRECT OPENING, 1/2 NPT, SILVER CONTA

Safety Door Switch, 4PST, Momentary, 250VDC, Wire Terminal, Panel Mount

Cable Pull Switch; Actuator Style:Ball Bearing Plunger; Circuitry:4PST-3NC/1NO; Cable Span:250ft; Contact Material:Silver; Operating Temp. Max:+85°C; Operating Temp. Min:-25°C; Port Style:NPT; Mechanical Life Operations:1000000 ;RoHS Compliant: Yes

HONEYWELL MICRO SWITCH 1CPSA3 Cable Pull Switch, Single, 10A, 3NC/1NO. More details: Emergency Cable Pull Switch, Switch Function Maintained, Contact Form 3NC/1NO, Mounting Style Single End, Indicator No, Rotary Knob Reset, Max. Cable Span 250 ft., Length 10.62 In., Width 3.90 In., Depth 2.57 In., Switching Ability Single Cable, AC Contact Rating 10A, DC Contact Rating 2.5A, Min. Current 50 mA to 10 A (Thermal), Operating Force 3 to 5 lb., Case Material Zinc Die Cast, Wiring Entry 1/2 In. NPT, NEMA Rating 1, 4, 12, 13, IP Rating 67, For Use With Microswitch CPS Accessories

The 1CPS Cable Pull Safety Switch is intended for use in applications with the cable runs up to 76 m [250 ft], such as conveyor runs within defined system zones. It is a cost-effective means of providing this emergency stop signal compared to multiple emergency stop push buttons. (Cable Pull Safety Switches are not, however, to be used as a means of personnel safeguarding. They may be used to prevent further injury or damage to equipment when used for emergency stop signaling.) The 1CPS Series Cable Pull Safety Switch is designed to provide emergency stop protection for exposed conveyor lines. The internal mechanism latches on both slackened cable (push) and pulled cable. This capability enhances productivity by eliminating nuisance stops due to variations in temperature, stretch of cable over time, and other application variables. A line in the midpoint of the cable tension window indicates proper cable tension, providing easy and intuitive set-up. The direct acting switch contacts are held closed when the actuating cable is under proper tension and the reset knob is set to RUN. When the actuating cable is pulled, slackened or broken, a cam positively opens the NC (Normally Closed) switch contacts. The snap action, trip operation causes the switch contacts to change state and mechanically latch almost simultaneously when the cable is pulled, slackened or broken. The NC switch contacts remain open until the 1CPS is reset by properly tensioning the cable and manually rotating the reset knob. When the direct acting switch contacts open, the auxiliary contacts also actuate (open contacts close and closed contacts open). The auxiliary contacts are electrically isolated from the direct acting switch contacts. These NO (Normally Open) contacts may be used for monitoring or signaling. The 1CPS complies with: Low Voltage Directive 73/23/EEC, as amended by directive 93/68/EEC; Machinery Directive 98/37/EEC only as the directives relate to the components being used in a safety function; IEC/EN60947-1; IEC/EN60947-5-1; IEC/