onsemi FAN5234MTCX

FAN5234 Series 24 V 600 kHz Dual Mobile-Friendly PWM / PFM Controller - TSSOP-16

Switching Controller, Current-mode, 690kHz Switching Freq-Max, PDSO16

DC DC Cntrlr Single=-OUT Step Down 690kHz 16-Pin TSSOP T/R

IC REG CTRLR MOBILE 1OUT 16TSSOP

AC-DC Controller And Voltage Regulator

Switching Regulators PWM Controller

PWM/PFM Controller, Wide Input Voltage

SWITCHING CONTROLLER, CURRENT-MO

Supply Voltage Min:4.75V; Supply Voltage Max:5.25V; No. Of Outputs:1 Output; Duty Cycle (%):100%; Controller Ic Case Style:tssop; No. Of Pins:16Pins; Switching Frequency:600Khz; Topology:buck (Step Down); Product Range:- Rohs Compliant: Yes

The FAN5234 PWM controller provides high efficiency and regulation with an adjustable output from 0.9V to 5.5V required to power I/O, chip-sets, memory banks, or peripherals in high-performance notebook computers, PDAs, and internet appliances. Synchronous rectification and hysteretic operation at light loads contribute to a high efficiency over a wide range of loads. The Hysteretic Mode of operation can be disabled if PWM Mode is desired for all load levels. Efficiency is further enhanced by using the MOSFET’s RDS(ON) as a current-sense component.Feed-forward ramp modulation, average current mode control, and internal feedback compensation provide fast response to load transients. The FAN5234 monitors these outputs and generates a PGOOD (power-good) signal when the soft-start is completed and the output is within 10% of its set point. A built-in over-voltage protection prevents the output voltage from going above 120% of the set point. Normal operation is automatically restored when the over-voltage conditions cease. Under-voltage protection latches the chip off when the output drops below 75% of its set value after the softstart sequence is completed. An adjustable over-current function monitors the output current by sensing the voltage drop across the lower MOSFET.