Analog Devices AD8400AR100

Digital Potentiometer 256POS 100KOhm Single 8-Pin SOIC N

500ppm/¡æ 100K¦¸ 256 1 2.7V Volatile 5.5V SPI Potentiometer SOIC-8 1.5mm

SPI Potentiometer Volatile 8-SOIC (0.154 3.90mm Width) digital potentiometer 2.7V~5.5V 100kOhm -40C~125C 卤30%

IC DGTL POT 100KOHM 256TAP 8SOIC

IC DGTL POT 8BIT 100K 1CH 8-SOIC

SINGLE 8-BIT DIGITAL POTENTIOM <NV

DIGITAL POTENTIOMETER (POTS) IC

The AD8400/AD8402/AD8403 provide a single, dual or quad channel, 256 position digitally controlled variable resistor (VR) device. These devices perform the same electronic adjustment function as a potentiometer or variable resistor. The AD8400 contains a single variable resistor in the compact SO-8 package. The AD8402 contains two independent variable resistors in saving SO-14 surface mount package. The AD8403 contains four independent variable resistors in 24-lead PDIP, SOIC and TSSOP packages. Each part contains a fixed resistor with a wiper contact that taps the fixed resistor value at a point determined by a digital code loaded into the controlling serial input register. The resistance between the wiper and either endpoint of the fixed resistor varies linearly with respect to the digital code transferred into the VR latch. Each variable resistor offers a completely programmable value of resistance, between the A terminal and the wiper or the B terminal and the wiper. The fixed A to B terminal resistance of 1 kOhm, 10 kOhm, 50 kOhm or 100 kOhm has a ±1% channel-to-channel matching tolerance with a nominal temperature coefficient of 500 ppm/°C. A unique switching circuit minimizes the high glitch inherent in traditional switched resistor designs avoiding any make-before-break or break-before-make operation. Each VR has its own VR latch that holds its programmed resistance value. These VR latches are updated from an SPI compatible serial-to-parallel shift register that is loaded from a standard 3-wire serial-input digital interface. Ten data bits make up the data word clocked into the serial input register. The data word is decoded where the first two bits determine the address of the VR latch to be loaded, the last eight bits are data. A serial data output pin at the opposite end of the serial register allows simple daisy-chaining in multiple VR applications without additional external decoding logic.