Analog Devices AD7680BRM

3 mW, 100 kSPS, 16-Bit ADC in 6-Lead SOT-23 | IC ADC 16BIT SAR 8MSOP

Single ADC SAR 100ksps 16-bit Serial 8-Pin MSOP Tube

Analog Devices AD7680BRM 16 Bit Analog to Digital Converter 1 Input 1 SAR 8-MSOP

GULL WING DUAL Supply SAR Analog to Digital Converter 0.0053% -40C~85C 5.5V 9.6mus

16BIT ADC, SMD, 7680, MSOP8; Termination Type:SMD; Case style:MSOP; Temperature, operating range:-40°C to +85°C; A/D, D/A features:DSP, MicroWire, QSPI, SPI; Base number:7680; Bits, No. of:16; IC Generic number:7680; Linearity error, ADC/DAC +:4LSB; Linearity error, ADC/DAC -:4LSB; Logic function number:7680; Pins, No. of:8; Power, Ptot:26.4mW; Temp, op. max:85°C; Temp, op. min:-40°C; Time, conversion:8µs; Voltage, Vcc:5V

The AD7680 is a 16-bit, fast, low power, successive approximation ADC. The part operates from a single 2.5 V to 5.5 V power supply and features throughput rates up to 100 kSPS. The part contains a low noise, wide bandwidth track-and-hold amplifier that can handle input frequencies in excess of 7 MHz. The conversion process and data acquisition are controlled using CS and the serial clock, allowing the devices to interface with microprocessors or DSPs. The input signal is sampled on the falling edge of CS and the conversion is also initiated at this point. There are no pipelined delays associated with the part. The AD7860 uses advanced design techniques to achieve very low-power dissipation at fast throughput rates. The reference for the part is taken internally from VDD. This allows the widest dynamic input range to the ADC. Thus the analog input range for the part is 0 to VDD. The conversion rate is determined by the SCLK frequency. Product Highlights First 16-bit ADC in a SOT-23 package. High throughput with low power consumption. Flexible power/serial clock speed management. The conversion rate is determined by the serial clock, allowing the conversion time to be reduced through the serial clock speed increase. This allows the average power consumption to be reduced when a power-down mode is used while not converting. The part also features a shutdown mode to maximize power efficiency at lower throughput rates. Power consumption is 0.5 μA max when in shutdown. Reference derived from the power supply. No pipeline delays. Applications Process control Battery-powered systems: Personal digital assistants Medical instruments Mobile communications Instrumentation and control systems Remote data acquisition systems High speed modems Optical sensors