Texas Instruments SN74ACT7805-25DLR

74ACT7805 Width Cut Tape (CT) 74ACT fifo memory 40MHz 400muA 0.635mm 15ns

FIFO Mem Sync Dual Width Uni-Dir 256 x 18 56-Pin SSOP T/R

IC SYNC FIFO MEM 256X18 56-SSOP / Synchronous FIFO 4.5K (256 x 18) Uni-Directional 40MHz 15ns 56-SSOP

The SN74ACT7805 is a 256-word 18-bit clocked FIFO suited for buffering asynchronous data paths up to 67-MHz clock rates and 12-ns access times. Two devices can be configured for bidirectional data buffering without additional logic. Multiple distributed VCC and GND pins, along with Texas Instruments patented output edge control (OECTM) circuit, dampen simultaneous switching noise. The write clock (WRTCLK) and read clock (RDCLK) are free running and can be asynchronous or coincident. Data is written to memory on the rising edge of WRTCLK when WRTEN1 is high, WRTEN2\ is low, and IR is high. Data is read from memory on the rising edge of RDCLK when RDEN\, OE1\, and OE2\ are low and OR is high. The first word written to memory is clocked through to the output buffer, regardless of the RDEN\, OE1\, and OE2\ levels. The OR flag indicates that valid data is present on the output buffer. The FIFO can be reset asynchronously to WRTCLK and RDCLK. RESET\ must be asserted while at least four WRTCLK and four RDCLK rising edges occur to clear the synchronizing registers. Resetting the FIFO initializes the input-ready (IR), output-ready (OR), and half-full (HF) flags low and the almost-full/almost-empty (AF/AE) flag high. The FIFO must be reset upon power up. The SN74ACT7805 is characterized for operation from 0C to 70C.