onsemi MM74HCT574MTCX

Flip Flop D-Type Bus Interface Pos-Edge 3-ST 1-Element 20-Pin TSSOP T/R

3-STATE Octal D-Type Flip-Flop

Tape & Reel (TR) 74HCT574 e4 74HCT flip flop 6.5mm 30ns @ 5V 50pF 33MHz 30ns

4.5V~5.5V 33MHz 30ns@5V,50pF D-Type 8 1 8uA TSSOP-20 Flip Flops ROHS

8¦ÌA 30ns@ 5V,50pF , 1 4.5V 5.5V 7.2mA Standard HCT 10pF 7.2mA 33MHz TSSOP-20 6.5mm*4.4mm*900¦Ìm

Ic, flip-Flop, octal, d Type, hct-Cmos, tssop,20Pin, plastic Rohs Compliant: Yes |Onsemi MM74HCT574MTCX

Bus Driver, HCT Series, 1-Func, 8-Bit, True Output, CMOS, PDSO20

IC FLIP FLOP OCT D 3ST 20TSSOP

IC FF D-TYPE SNGL 8BIT 20TSSOP

The MM74HCT573 octal D-type latches and MM74HCT574 octal D-type flip-flop advanced silicon-gate CMOS technology, which provides the inherent benefits of low power consumption and wide power supply range, but are LS-TTL input and output characteristic and pin-out compatible. The 3-STATE outputs are capable of driving 15 LS-TTL loads. All inputs are protected from damage due to static discharge by internal diodes to VCC and ground. When the MM74HCT573 Latch Enable input is HIGH, the Q outputs will follow the D inputs. When the Latch Enable goes LOW, data at the D inputs will be retained at the outputs until Latch Enable returns HIGH again. When a high logic level is applied to the Output Control input, all outputs go to a high impedance state, regardless of what signals are present at the other inputs and the state of the storage elements. The MM74HCT574 are positive edge triggered flip-flops. Data at the D inputs, meeting the setup and hold time requirements, are transferred to the Q outputs on positive going transitions of the Clock (CK) input. When a high logic level is applied to the Output Control (OC) input, all outputs go to a high impedance state, regardless of what signals are present at the other inputs and the state of the storage elements. The MM74HCT devices are intended to interface between TTL and NMOS components and standard CMOS devices. These parts are also plug in replacements for LS-TTL devices and can be used to reduce power consumption in existing designs.