onsemi MC100EP139DT

Low Skew Clock Driver, 100E Series, 4 True Output(s), 0 Inverted Output(s), ECL, PDSO20

DUAL Obsolete GULL WING Surface Mount Clock Generator IC 2007 -40C~85C 0.9ns 6.5mm

Amplifiers- Audio 3.3V/5V ECL Clock No-Cancel/No-Return

Clock Generators & Support Products 3.3V/5V ECL Clock

IC CLK GEN ECL 2/4 4/5/6 20TSSOP

The MC10/100EP139 is a low skew divide by 2/4 divide by 4/5/6 clock generation chip designed explicitly for low skew clock generation applications. The internal dividers are synchronous to each other therefore the common output edges are all precisely aligned. The device can be driven by either a differential or single-ended ECL or if positive power supplies are used LVPECL input signals. In addition by using the VBB output a sinusoidal source can be AC coupled into the device. If a single-ended input is to be used the VBB output should be connected to the CLKbar input and bypassed to ground via a 0.01uF capacitor. The common enable (ENbar) is synchronous so that the internal dividers will only be enabled/disabled when the internal clock is already in the LOW state. This avoids any chance of generating a runt clock pulse on the internal clock when the device is enabled/disabled as can happen with an asynchronous control. The internal enable flip-flop is clocked on the falling edge of the input clock therefore all associated specification limits are referenced to the negative edge of the clock input. Upon startup the internal flip-flops will attain a random state; therefore for systems which utilize multiple EP139s the master reset (MR) input must be asserted to ensure synchronization. For systems which only use one EP139 the MR pin need not be exercised as the internal divider design ensures synchronization between the divide by 2/4 and the divide by 4/5/6 outputs of a single device. All VCC and VEE pins must be externally connected to power supply to guarantee proper operation. The 100 Series contains temperature compensation.