onsemi 74VHC112MTC

Flip Flop JK-Type Neg-Edge 2-Element 16-Pin TSSOP Rail

Tube 74VHC112 e4 74VHC flip flop 173mg 2V 10.5ns @ 5V 50pF 185MHz

J-K Flip-Flop, AHC/VHC Series, 2-Func, Negative Edge Triggered, 2-Bit, Complementary Output, CMOS, PDSO16

IC FF JK TYPE DUAL 1BIT 16TSSOP

Dual J-K Flip-Flops with Preset and Clear

Negative edge 2μA 10.5ns@ 5V,50pF Antiphase，Non-inverting Complimentary 2 2V 5.5V 8mA Set(Preset) and Reset VHC Single ended 4pF 8mA 185MHz TSSOP-16 SMD mount 5mm*4.4mm*900μm

The VHC112 is an advanced high speed CMOS device fabricated with silicon gate CMOS technology. It achieves the high-speed operation similar to equivalent Bipolar Schottky TTL while maintaining the CMOS low power dissipation. The VHC112 contains two independent, high-speed JK flip-flops with Direct Set and Clear inputs. Synchronous state changes are initiated by the falling edge of the clock. Triggering occurs at a voltage level of the clock and is not directly related to transition time. The J and K inputs can change when the clock is in either state without affecting the flip-flop, provided that they are in the desired state during the recommended setup and hold times relative to the falling edge of the clock. The LOW signal on PR or CLR prevents clocking and forces Q and Q# HIGH, respectively. Simultaneous LOW signals on PR and CLR force both Q and Q# HIGH. An input protection circuit ensures that 0V to 7V can be applied to the input pins without regard to the supply voltage. This device can be used to interface 5V to 3V systems and two supply systems such as battery backup. This circuit prevents device destruction due to mismatched supply and input voltages.