Texas Instruments CDC857-2DGG

Gold DUAL Obsolete GULL WING PLL Clock Driver IC 0C~85C 6ns 0.5mm 12mA

IC, PLL CLOCK DRIVER, 167MHZ, TSSOP-48; Clock IC Type:PLL Clock Driver; Frequency:167MHz; No. of Outputs:10; Supply Current:235mA; Supply Voltage Range:2.3V to 2.7V; Digital IC Case Style:TSSOP; No. of Pins:48 ;RoHS Compliant: Yes

The CDC857-2 and CDC857-3 are high-performance, low-skew, low-jitter, phase-lock loop (PLL) clock driver. They use a PLL to precisely align, in both frequency and phase, the feedback (FBOUT) output to the clock (CLK) input signal. The CDC857-3 operates at 3.3 V (PLL) and 2.5 V (output buffer). The CDC857-2 operates at 2.5 V (PLL and output buffer). One bank of ten inverting and noninverting outputs provide ten low-skew, low-jitter copies of CLK. Output signal duty cycles are adjusted to 50%, independent of the duty cycle at CLK. All outputs can be enabled or disabled via a single output enable input. When the G input is high, the outputs switch in phase and frequency with CLK; when the G input is low, the outputs are disabled to high impedance state (3-state). Unlike many products containing PLLs, the CDC857 does not require external RC networks. The loop filter for the PLL is included on-chip, minimizing component count, board space, and cost. Because it is based on PLL circuity, the CDC857 requires a stabilization time to achieve phase lock of the feedback signal to the reference signal. This stabilization time is required following power up and application of a fixed-frequency, fixed-phase signal at CLK, as well as following any changes to the PLL reference or feedback signals. The PLL can be bypassed for test purposes by strapping AVCC to ground. If AVCC is at GND and VCC = ON, 2 falling edges on G cause the PLL to run with FBOUT being enabled and all other outputs being disabled, after AVCC ramps up to its specified VCC value, with G being kept low. The CDC857 is characterized for operation from 0C to 85C.