onsemi MC100E446FNG

Shift Register Single 4-Bit Serial/Parallel to Serial 28-Pin PLCC Tube

Parallel In Serial Out, 100E Series, 4-Bit, Right Direction, Complementary Output, ECL, PQCC28

Logic- Serial/Parallel Converters 5V ECL 4-Bit Serial to Parallel CNVRTR

5.0 V ECL 4-Bit Parallel to Serial Converter

IC CONV 4BIT SER/PAR ECL 28-PLCC

IC INTERFACE SPECIALIZED 28PLCC

Converter Logic IC; No. of Inputs:4; Output Current:50mA; Propagation Delay:1.2ns; Logic Type:Parallel / Serial Converter; Supply Voltage Range:4.2V to 5.7V; Logic Case Style:LCC; No. of Pins:28 ;RoHS Compliant: Yes

The MC10E/100E446 is an integrated 4-bit parallel to serial data converter. The device is designed to operate for NRZ data rates of up to 1.3 Gb/s. The chip generates a divide by 4 and a divide by 8 clock for both 4-bit conversion and a two chip 8-bit conversion function. The conversion sequence was chosen to convert the parallel data into a serial stream from bit D0 to D3. A serial input is provided to cascade two E446 devices for 8 bit conversion applications. Note that the serial output data clocks off of the negative input clock transition. The SYNC input will asynchronously reset the internal clock circuitry. This pin allows the user to reset the internal clock conversion unit and thus select the start of the conversion process. The MODE input is used to select the conversion mode of the device. With the MODE input LOW or open the device will function as a 4-bit converter. When the mode input is driven HIGH the internal load clock will change on every eighth clock cycle thus allowing for an 8-bit conversion scheme using two E446s. When cascaded in an 8-bit conversion scheme the devices will not operate at the 1.3 Gb/s data rate of a single device. Refer to the applications section of this data sheet for more information on cascading the E446. The VBB pin an internally generated voltage supply is available to this device only. For single-ended input conditions the unused differential input is connected to VBB as a switching reference voltage. VBB may also rebias AC coupled inputs. When used decouple VBB and VCC via a 0.01 F capacitor and limit current sourcing or sinking to 0.5 mA. When not used VBB should be left open. The 100 Series contains temperature compensation.