Infineon TLE4998S8XUMA1

Hall Effect Sensor, -50mT Min, 200mT Max, 0-5mA, Rectangular, 8 Pin, Surface Mount

Integration of two individual Linear Hall sensor IC’s with Single Edge Nibble Transmission (SENT) open-drain, PG-TDSO-8, RoHS

Hall Effect Sensor, Aec-Q100, Tssop-8; Sensor Case/Package:Tssop; No. Of Pins:8Pins; Supply Voltage Min:4.5V; Supply Voltage Max:5.5V; Operating Temperature Min:-40°C; Operating Temperature Max:125°C; Product Range:Xensiv Series Rohs Compliant: Yes |Infineon Technologies TLE4998S8XUMA1

The linear Hall IC TLE4998S8 has been designed specifically to meet the requirements of highly accurate angle and position detection. The sensor provides a digital SENT signal based on the SAE J2716 standard, which consists of a sequence of pulses. Each transmission consists of multiple data nibbles containing the Hall value, the temperature and status information of the sensor. The output stage is an open-drain driver pulling the output pin to low only. Therefore, the high level needs to be obtained by an external pull-up resistor. This output type has the advantage that the receiver may use an even lower supply voltage (e.g. 3.3 V). In this case the pull-up resistor must be connected to the given receiver supply.