onsemi FAN5026MTCX

FAN5026 Series 3 to 16 V 300 kHz Dual-Output PWM Controller - TSSOP-28

Dual Switching Controller, Current-mode, 5A, 345kHz Switching Freq-Max, PDSO28

PWM Controller IC; Controller Type:PWM; Input Voltage Primary Max:16V; Output Voltage Max:15V; Output Type:Voltage; Input Current:3mA; Frequency:300kHz; Supply Voltage Min:4.75V; Termination Type:SMD; No. of Pins:28 ;RoHS Compliant: Yes

PWM CONTROLLER, SMD, 5026, TSSOP28; Input Voltage:16V; Output Voltage:5.5V; Output Current:5A; Frequency:300kHz; Supply Voltage Range:4.75V to 5.25V; Digital IC Case Style:TSSOP; No. of Pins:28; Operating Temperature Range:-40°C to +85°C; SVHC:Cobalt dichloride (18-Jun-2010); Case Style:TSSOP; Max Operating Temperature:85°C; Min Temperature Operating:-40°C; Base Number:5026; Controller Type:PWM; IC Generic Number:5026; Logic Function Number:5026; Max Input Voltage:16V; Max Output Voltage:5.5V; Max Supply Voltage:5.25V; Min Supply Voltage:4.75V; Output Type:Voltage; SVHC (Secondary):Bis (2-ethyl(hexyl)phthalate) (DEHP) (18-Jun-2010); Termination Type:SMD; Min Input Voltage:3V; Min Output Voltage:0.9V

The FAN5026 PWM controller provides high efficiency and regulation for two output voltages adjustable in the range from 0.9v to 5.5V that are required to power I/O, chip-sets, and memory banks in high-performance computers, set-top boxes, and VGA cards. Synchronous rectification contributes to high efficiency over a wide range of loads. Efficiency is even further enhanced by using MOSFET RDS(ON) as a current-sense component. Feedforward ramp modulation, average-current mode control scheme, and internal feedback compensation provide fast response to load transients. Out-of-phase operation with 180° phase shift reduces input current ripple. The controller can be transformed into a complete DDR memory power supply solution by activating a designated pin. In DDR Mode, one of the channels tracks the output voltage of another channel and provides output current sink and source capability — essential for proper powering of DDR chips. The buffered reference voltage required by this type of memory is also provided. The FAN5026 monitors these outputs and generates separate PGx (power good) signals when the soft-start is completed and the output is within 10% of its set point. Over-voltage protection prevents the output voltage from exceeding 120% of the set point. Normal operation is automatically restored when the over-voltage conditions cease. Under-voltage protection latches the chip off when either output drops below 75% of its set value after the soft-start sequence for this output is completed. An adjustable over-current function monitors the output current by sensing the voltage drop across the lower MOSFET. If precision current-sensing is required, an external current-sense resistor may be used.