Texas Instruments TAS5162DDV

Audio Amp Speaker 1-CH Mono/2-CH Stereo 400W Class-AB 44-Pin HTSSOP EP Tube

0.09%@ 6¦¸ @ 1W 2-Channel (Stereo) 10.8V 210*2 @ 6¦¸ 13.2V 3¦¸ D HTSSOP-44 14mm*6.1mm*1.05mm

TEXAS INSTRUMENTS TAS5162DDV. Audio Power Amplifier, D, 2 Channel, 210 W, 0V to 52.5V, 10.8V to 13.2V, HTSSOP, 44 Pins

2 X 210 WATT STEREO DIGITAL AMPLIFIER POWER STAGE

IC, AMP AUDIO PWR 210W D 44TSSOP

EAR99 TAS5162 Tube Digital Inputs Short-Circuit and Thermal Protection Shutdown audio amplifier 10.8V 1.15mm 210W x 2 @ 6Ohm 15mA

The TAS5162 is a high performance, integrated stereo digital amplifier power stage with an improved protection system. The TAS5162 is capable of driving a 6- bridge-tied load (BTL) at up to 210 W per channel at THD = 10%, low integrated noise at the output, low THD+N performance without clipping, and low idle power dissipation. A low-cost, high-fidelity audio system can be built using a TI chipset, comprising a modulator (e.g., TAS5508) and the TAS5162. This system only requires a simple passive LC demodulation filter to deliver high-quality, high-efficiency audio amplification with proven EMI compliance. This device requires two power supplies, at 12 V for GVDD and VDD, and at 50V for PVDD. The TAS5162 does not require power-up sequencing due to internal power-on reset. The efficiency of this digital amplifier is greater than 90% into 6 , which enables the use of smaller power supplies and heatsinks. The TAS5162 has an innovative protection system integrated on-chip, safeguarding the device against a wide range of fault conditions that could damage the system. These safeguards are short-circuit protection, overcurrent protection, undervoltage protection, and overtemperature protection. The TAS5162 has a new proprietary current-limiting circuit that reduces the possibility of device shutdown during high-level music transients. A new programmable overcurrent detector allows the use of lower-cost inductors in the demodulation output filter.