onsemi CAT1832L-G

Voltage Supervisor, Watchdog Timer, Manual Reset, 3.3 V, with Active High and Low Resets

Voltage Supervisor/Reset IC, Fixed, 1 Channel, +3.3V, CMOS, PDIP8

CAT1832L-G, VOLTAGE SUPERVISOR, 3.3 V, WDT, RESET INPUT, 8-PIN SOIC

IC SUPERVISOR 1 CHANNEL 8DIP / Supervisor Push-Pull, Totem Pole 1 Channel 8-PDIP

Processor Supervisor 2.88V/2.55V 3.3V/5V 8-Pin PDIP Rail

The CAT1832 voltage supervisor can halt and restart a hung-up or stalled microprocessor restart a microprocessor after a power failure and debounce a manual/push-button microprocessor reset switch. The device is a drop in replacement for the Maxim/Dallas Semiconductor DS1832 supervisor. Precision reference and comparator circuits monitor the 3.3 V system power supply voltage VCC. During power-up or when the power supply falls outside selectable tolerance limits both the RESET and RESET become active. After the power supply voltage rises above the RESET threshold voltage the reset signals remain active for a minimum of 250 ms allowing the power supply and system processor to stabilize. The trip-point tolerance input TOL selects the trip level tolerance to be 10% or 20% for the CAT1832 3.3 V supply. Each device has a push-pull active HIGH reset output. The CAT1832 also has a push-pull active LOW reset output. A debounced manual reset input activates the reset outputs and holds them active for a minimum period of 250 ms after being released. Also included is a watchdog timer to reset a microprocessor that has stopped due to a software or hardware failure. Three watchdog time-out periods are selectable: 150 ms 600 ms and 1.2 sec. If the ST input is not strobed low before the watchdog time out period expires the reset signals become active for a minimum of 250 ms.