Texas Instruments PC16550DVX

Universal Asynchronous eceiver/Transmitter with FIFOs 44-PLCC 0 to 70

UART 1-CH 16Byte FIFO 5V 44-Pin PLCC T/R

1 CHANNEL(S) 1.5M bps SERIAL COMM CONTROLLER PQCC44

Contains Lead J BEND SERIAL IO/COMMUNICATION CONTROLLER SERIAL Obsolete UART IC 4.5V~5.5V 1.5Mbps 16Byte 24MHz

UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER WITH FIFOS Serial I/O Controller, 1 Channel(s), 0.1875MBps, CMOS, PQCC44

IC RCVR/TX UNIVER W/FIFO 44-PLCC

SERIAL I/O CONTROLLER, 1 CHANNEL

The PC16550D is an improved version of the original 16450 Universal Asynchronous Receiver/Transmitter (UART). Functionally identical to the 16450 on power up (CHARACTER mode)* the PC16550D can be put into an alternate mode (FIFO mode) to relieve the CPU of excessive software overhead. In this mode internal FIFOs are activated allowing 16 bytes (plus 3 bits of error data per byte in the RCVR FIFO) to be stored in both receive and transmit modes. All the logic is on chip to minimize system overhead and maximize system efficiency. Two pin functions have been changed to allow signalling of DMA transfers. The UART performs serial-to-parallel conversion on data characters received from a peripheral device or a MODEM, and parallel-to-serial conversion on data characters received from the CPU. The CPU can read the complete status of the UART at any time during the functional operation. Status information reported includes the type and condition of the transfer operations being performed by the UART, as well as any error conditions (parity, overrun, framing, or break interrupt). The UART includes a programmable baud rate generator that is capable of dividing the timing reference clock input by divisors of 1 to (216b1), and producing a 16 c clock for driving the internal transmitter logic. Provisions are also included to use this 16 c clock to drive the receiver logic. The UART has complete MODEM-control capability, and a processor-interrupt system. Interrupts can be programmed to the user's requirements, minimizing the computing required to handle the communications link. The UART is fabricated using National Semiconductor's advanced M2CMOS process. *Can also be reset to 16450 Mode under software control. s^Note: This part is patented.