onsemi FPF1048BUCX

IntelliMAX™ 3A-Capable, Slew-Rate-Controlled Load Switch with True Reverse Current Blocking

FPF1048 Series 5.5 V 3 A 28 mOhm Slew Rate Controlled Load Switch - WLCSP-6

Tape & Reel (TR) FPF1048 Reverse Current e1 power distribution switch 1mm 5.5V 3A 1.2W

Power Switch ICs - Power Distribution IntelliMAX Slew Rate Cont'd Load Switch

POWER LOAD SW, -40 TO 85DEGC, WLCSP-6; Available until stocks are exhausted

TAPE REEL/Low On Resistance, Long Siew Rate Controlled Load

Power Switch Hi Side 1-OUT 2.5A 0.09Ohm 6-Pin WLCSP T/R

SPST, 1 Func, 1 Channel, PBGA6

IC LOAD MGMT SWITCH ADV 6-WLCSP

The FPF1048B advanced load management switch targets applications requiring a highly integrated solution. It disconnects loads powered from the DC power rail (<6V) with stringent off-state current targets and high load capacitances (up to 100µF). The FPF1048B consists of slew-rate controlled low-impedance MOSFET switch (23mΩ typical) and integrated analog features. The slew-rate controlled turn-on characteristic prevents inrush current and the resulting excessive voltage droop on power rails. The FPF1048B has a True Reverse Current Blocking (TRCB) function that obstructs unwanted reverse current from VOUT to VIN during both ON and OFF states. The exceptionally low off-state current drain (<1µA maximum) facilitates compliance with standby power requirements. The input voltage range operates from 1.5V to 5.5VDC to support a wide range of applications in consumer, optical, medical, storage, portable, and industrial device power management. Switch control is managed by a logic input (active HIGH) capable of interfacing directly with low-voltage control signal / General-Purpose Input / Output (GPIO) without an external pull-down resistor. The device is packaged in advanced, fully “green” compliant, 1.0mm x 1.5mm, Wafer-Level Chip-Scale Package (WLCSP) with backside lamination.