Infineon TLE7368EXUMA3

Power Management IC, 45V Supply, 3 LDO Regulators, 3 Regulated Outputs, SOIC-36

Buck,Charge Pump,Positive No 370KHz 3 5V,3.3V,2.6V,1.3V 1.2V 45V 4.5V SOP

The TLE7368 device is a multifunctional power supply circuit especially designed for Automotive powertrain systems using a standard 12 V battery, PG-DSO-36, RoHS

PWR MANAGEMENT IC, AEC-Q100, SOIC-36; Supply Voltage: 45V; No. of Step-Down DC - DC Converters: -; No. of LDO Regulators: 3; No. of Regulated Outputs: 3; Digital IC Case: SOIC; No. of Pins: 36Pins; Operating Temperature Min: -4

Power Management Ic, -40 To 150Deg C; Ic Type:Pmic For Microcontroller Applications; Supply Voltage:45V; No. Of Step-Down Dc - Dc Converters:-; No. Of Ldo Regulators:3; No. Of Regulated Outputs:3; Ic Case/Package:Soic; Msl:- Rohs Compliant: Yes |Infineon Technologies TLE7368EXUMA3

The device is intended to supply and monitor next generation 32-bit microcontroller families (13 μm lithography) where voltage levels such as 5 V, 3.3 V or 1.5 V are required. The regulator follows the concept of its predecessor TLE6368, where the output of a pre-regulator feeds the inputs of the micro’s linear supplies. In detail, the TLE7368 cascades a Buck converter with linear regulators and voltage followers to achieve lowest power dissipation. This configuration allows to power the application even at high ambient temperatures. The step-down converter delivers a pre-regulated voltage of 5.5 V with a minimum peak current capability of 2.5 A. Supplied by this step down converter two low drop linear post-regulators offer 5 V and 3.3 V (2.6 V) with high accuracy. The current capability of the regulators is 800 mA and 700 mA. The 3.3 V (2.6 V) linear regulator does have its own input allowing to insert a dropper from the Buck output to reduce the on chip power dissipation if necessary. For the same reason, reduction of on chip power dissipation, the core supply (1.5 V, 1.2 V or 1.3 V) follows the concept of integrated control circuit with external power stage. Implementing the on board and microcontroller supplies in this way described, allows operation even at high ambient temperatures.The regulator system contains the so called power sequencing function which provides a controlled power up sequence of the three output voltages. In addition to the main regulators the inputs of two voltage trackers are connected to the 5.5 V Buck converter output voltage. Their protected outputs follow the main 5 V linear regulator with high accuracy and are able to drive loads of 50 mA and 105 mA. To monitor the output voltage levels of each of the linear regulators two independent undervoltage detection circuits are available. They can be used to implement the reset or an interrupt function. For energy saving reasons, e.g. while the motor is turned off, the TLE7368 offers a stand-by mode. The standby mode can be enabled and disabled either by battery or the microcontroller. In this stand-by mode just the standby regulator remains active and the current drawn from battery is reduced to a minimum for extended battery lifetime. A selection pin allows to configure the output voltages of the stand-by regulator to the application’s needs.The input of the stand-by regulator is separated from the high power input of the pre-/post-regulator system. The TLE7368 is based on Infineon’s Power technology SPT™ which allows bipolar, CMOS and power DMOS circuitry to be integrated on the same monolithic chip/circuitry.