Honeywell SSCDANN020NG2A3

Sensor, TruStability, Pressure, DIP, 2- in H2O Gauge, I2C, 3.3 V Supply

Pressure Sensor 0inH2O to 20inH2O Gage 8-Pin DIP

PRESSURE SENSOR, 0 TO 20INCH-H2O, 1; Operating Pressure Range:0inch-H2O to 20inch-H2O; Sensor Output:Digital; Supply Current:1.6mA; Voltage Rating:3.3V; Port Style:Axial; Pressure Measurement Type:Gage; Sensor Interface:PCB Mount

SENSOR, TRUSTABILITY, 20IN H2O, 3.3V; SVHC:No SVHC (20-Jun-2011); Accuracy:±0.25%; Input Type:Axial, single port; Operating Temperature Range:-20°C to +85°C; Output Type:Digital; Pressure Type:Gauge; Supply Voltage V DC:3.3V; Termination Type:DIP

TruStability™ SSC Series-Standard Accuracy, digital I²C address: 0x28, DIP AN: single axial barbed port, gage, 0 inH2O to 12 inH2O, 3.3 Vdc, no special options The TruStability™ Standard Accuracy Silicon Ceramic (SSC) Series is a piezoresistive silicon pressure sensor offering a ratiometric analog or digital output for reading pressure over the specified full scale pressure span and temperature range. The SSC Series is fully calibrated and temperature compensated for sensor offset, sensitivity, temperature effects, and nonlinearity using an on-board Application Specific Integrated Circuit (ASIC). Calibrated output values for pressure are updated at approximately 1 kHz for analog and 2 kHz for digital. The SSC Series is calibrated over the temperature range of -20 °C to 85 °C [-4 °F to 185 °F]. The sensor is characterized for operation from a single power supply of either 3.3 Vdc or 5.0 Vdc. These sensors measure absolute, gage, or differential pressures. The absolute versions have an internal vacuum reference and an output value proportional to absolute pressure. Gage versions are referenced to atmospheric pressure and provide an output proportional to pressure variations from atmosphere. Differential versions allow measurement of pressure between two pressure ports. The TruStability™ pressure sensors are intended for use with non-corrosive, non-ionic gases, such as air and other dry gases. Available options extend the performance of these sensors to non-corrosive, non-ionic liquids for pressure ranges above 40 mbar | 4 kPa | 20 inH2O. All products are designed and manufactured according to ISO 9001 standards.