Analog Devices ADUCM330WDCPZ

MCU 32-bit ARM Cortex M3 RISC 96KB Flash Automotive Medical 32-Pin LFCSP EP Tray

Mcu, 32Bit, Cortex-M3, 16.384Mhz, Lfcsp

IC MCU 32BIT 96KB FLASH 32LFCSP

The ADuCM330 is a fully integrated, 8 kSPS, data acquisition system that incorporates dual, high performance multichannel sigma-delta (Σ-Δ) ADCs, 32-bit ARM® Cortex™-M3 processor and flash. The ADuCM330 has 96 kB program flash and 4 kB data flash. The ADuCM330 is a complete system solution for battery monitoring in 12 V automotive applications. The ADuCM330 integrates all of the required features to precisely and intelligently monitor, process, and diagnose 12 V battery parameters including battery current, voltage, and temperature over a wide range of operating conditions. Minimizing external system components, the device is powered directly from a 12 V battery. On-chip, low dropout (LDO) regulators generate the supply voltage for two integrated Σ-Δ ADCs. The ADCs precisely measure battery current, voltage, and temperature to characterize the state of the health and the charge of the car battery. The device operates from an on-chip, 16.384 MHz high frequency oscillator that supplies the system clock. This clock is routed through a programmable clock divider from which the core clock operating frequency is generated. The device also contains a 32 kHz oscillator for low power operation. The analog subsystem consists of an ADC with a programmable gain amplifier (PGA) that allows the monitoring of various current and voltage ranges. It also includes a precision reference on chip. The ADuCM330 integrates a range of on-chip peripherals that can be configured under core software control as required in the application. These peripherals include a SPI serial input/output communication controller, six GPIO pins, one general-purpose timer, a wake-up timer, and a watchdog timer. The ADuCM330 is specifically designed to operate in battery-powered applications where low power operation is critical. The microcontroller core can be configured in normal operating mode, resulting in an overall system current consumption of <18.5 mA when all peripherals are active. The device can also be configured in a number of low power operating modes under direct program control, consuming <100 µA. The ADuCM330 also includes a LIN physical interface for single wire, high voltage communications in automotive environments. The device operates from an external 3.6 V to 18 V (on VDD, Pin 26) voltage supply and is specified over the −40°C to +115°C temperature range, with additional typical specifications at +125°C. APPLICATIONS Battery sensing/management for automotive and light mobility vehicles Lead-acid battery measurement for power supplies in industrial and medical domains