onsemi CAT5113LI-00-G

CAT5113 Series 100 Tap 100 Kohm Serial Interface Digital Potentiometer - PDIP-8

RoHS Compliant DUAL Through Hole Linear Digital Potentiometer ±20% -40C~85C 100muA 9.27mm

Digital Potentiometer 100kOhm 100POS Non-Volatile Linear 8-Pin PDIP Tube

Digital Potentiometer (POT), 100-Tap 100 kΩ

Digital Potentiometer 100POS 100k Ohm Single 8-Pin PDIP Rail

Digital Potentiometer, 1 Func, 100000ohm, Increment/decrement Control Interface, 100 Positions, PDIP8

The CAT5113 is a single digitally programmable potentiometer (DPP) designed as a electronic replacement for mechanical potentiometers. Ideal for automated adjustments on high volume production lines they are also well suited for applications where equipment requiring periodic adjustment is either difficult to access or located in a hazardous or remote environment. The CAT5113 contains a 100-tap series resistor array connected between two terminals RH and RL. An up/down counter and decoder that are controlled by three input pins determines which tap is connected to the wiper RW. The CAT5113 wiper is buffered by an op amp that operates rail to rail. The wiper setting stored in non-volatile NVRAM memory is not lost when the device is powered down and is automatically recalled when power is returned. The wiper can be adjusted to test new system values without affecting the stored setting. Wiper-control of the CAT5113 is accomplished with three input control pins CS U/D and INC. The INC input increments the wiper in the direction which is determined by the logic state of the U/D input. The CS input is used to select the device and also store the wiper position prior to power down. The digitally programmable potentiometer can be used as a three-terminal resistive divider or as a two-terminal variable resistor.