Honeywell SSCMRNN100MG2A5

Board Mount Pressure Sensor 0bar to 0.1bar Gage Medical 8-Pin SMD Module

Board Mount Pressure Sensors SMT, Sing Rad Barbed Gage, 5V

Board Mount Pressure Sensors 5V RADIAL PORT 100mBar GAUGE SMT

Piezoresistive Sensor, Gage, 0Psi Min, 1.45Psi Max, 0.25%, 1-4V, Rectangular, Through Hole Mount

10Kpa SMD-8P Pressure Sensors ROHS

SENSOR 1.45PSIG 0.08" 12BIT 8SMT

Pressure Sensor, Gauge, 0-100Mbar; Pressure Type:Gauge; Operating Pressure Min:0Mbar; Operating Pressure Max:100Mbar; Supply Voltage Min:5.25Vdc; Supply Voltage Max:4.75Vdc; Sensor Case/Package:-; No. Of Pins:8Pins; Qualification:-Rohs Compliant: Yes |Honeywell SSCMRNN100MG2A5

TruStability™ SSC Series-Standard Accuracy, digital I²C address: 0x28, SMT RN: single radial barbed port, gage, 0 mbar to 100 mbar, 5.0 Vdc, dry gases only, no special options The TruStability™ Standard Accuracy Silicon Ceramic (SSC) Series is a piezoresistive silicon pressure sensor offering a ratiometric analog or digital output for reading pressure over the specified full scale pressure span and temperature range. The SSC Series is fully calibrated and temperature compensated for sensor offset, sensitivity, temperature effects, and nonlinearity using an on-board Application Specific Integrated Circuit (ASIC). Calibrated output values for pressure are updated at approximately 1 kHz for analog and 2 kHz for digital. The SSC Series is calibrated over the temperature range of -20 °C to 85 °C [-4 °F to 185 °F]. The sensor is characterized for operation from a single power supply of either 3.3 Vdc or 5.0 Vdc. These sensors measure absolute, gage, or differential pressures. The absolute versions have an internal vacuum reference and an output value proportional to absolute pressure. Gage versions are referenced to atmospheric pressure and provide an output proportional to pressure variations from atmosphere. Differential versions allow measurement of pressure between two pressure ports. The TruStability™ pressure sensors are intended for use with non-corrosive, non-ionic gases, such as air and other dry gases. Available options extend the performance of these sensors to non-corrosive, non-ionic liquids for pressure ranges above 40 mbar | 4 kPa | 20 inH2O. All products are designed and manufactured according to ISO 9001 standards.