Texas Instruments VFC320CP

Voltage to Frequency and Frequency to Voltage Converter (VFC/FVC) 1MHz 14-Pin PDIP

Voltage-to-frequency and frequency-to-voltage converter with 0.1% linearity error at 1 MHz 14-PDIP -25 to 85

Voltage to Frequency & Frequency to Voltage Volt to Freq and Freq to Volt Conv

VOLTAGE TO FREQUENCY AND FREQUENCY TO VOLTAGE CONVERTER Voltage to Frequency Converter, 1 Func, 1MHz, CMOS, PDIP14

Texas Instruments Voltage Frequency Converts, VFC/FVC, 1000kHz, voltage conversion, PDIPencapsulation

V/F & F/V CONVERTER 1MHZ 0.1% 14 DIP

ROHS3Compliant Nickel/Palladium/Gold (Ni/Pd/Au) Through Hole ±20ppm/C F/V converter 15V 19.3mm 1MHz 85C

VFC320 VOLTAGE-TO-FREQUENCY AND

The VFC320 monolithic voltage-to-frequency and frequency-to-voltage converter provides a simple low cost method of converting analog signals into digital pulses. The digital output is an open collector and the digital pulse train repetition rate is proportional to the amplitude of the analog input voltage. Output pulses are compatible with TTL, and CMOS logic families. High linearity (0.005%, max at 10kHz FS) is achieved with relatively few external components. Two external resistors and two external capacitors are required to operate. Full scale fre-quency and input voltage are determined by a resistor in series with -In and two capacitors (one-shot timing and input amplifierintegration). The other resistor is a non-critical open collector pull-up (fOUT to +VCC). The VFC320 is available in two perfor-mance grades. The VFC320 is specified for the -25oC to +85oC, range.