onsemi CAT5116LI-G

IC POT DIG LOG 32K 100TAP 8DIP / Digital Potentiometer 32k Ohm 1 Circuit 100 Taps Interface 8-PDIP

RoHS Compliant THROUGH-HOLE INDUSTRIAL 2011 Digital Potentiometer -40C 100muA 9.27mm 32kOhm

Digital Potentiometer 32kOhm 100POS Non-Volatile Log 8-Pin PDIP Tube

Digital Potentiometer (POT), Log Taper, 100-Tap

Digital Potentiometer, 1 Func, 32000ohm, Increment/decrement Control Interface, 100 Positions, PDIP8

100μA ±300ppm/℃ logarithm 32KΩ 100 1 2.5V Non-Volatile 6V Serial(3-Wire) PDIP-8 Through hole mounting 9.27mm*6.35mm*3.3mm

The CAT5116 is a log-taper single digitally programmable potentiometer (DPP) designed as a electronic replacement for mechanical potentiometers Ideal for automated adjustments on high volume production lines DPP ICs are well suited for applications where equipment requiring periodic adjustment is either difficult to access or located in a hazardous or remote environment. The CAT5116 contains a 100-tap series resistor array connected between two terminals RH and RL. An up/down counter and decoder that are controlled by three input pins determines which tap is connected to the wiper RW. The wiper setting stored in nonvolatile memory is not lost when the device is powered down and is automatically reinstated when power is returned. The wiper can be adjusted to test new system values without effecting the stored setting. Wiper-control of the CAT5116 is accomplished with three input control pins CS U/D and INC. The INC input increments the wiper in the direction which is determined by the logic state of the U/D input. The CS input is used to select the device and also store the wiper position prior to power down. The digitally programmable potentiometer can be used as a three-terminal resistive divider or as a two-terminal variable resistor.