STMicroelectronics LD1086DT18TR

LD1086 Series 1.5 A 1.8 V Fixed Output Positive Voltage LDO Regulator - DPAK

1.5 A adjustable and fixed low drop positive voltage regulator

LD1086DT18TR, LDO VOLTAGE REGULATOR, 1.5A, 1.8 V +/-1%, 3-PIN DPAK

Fixed Positive LDO Regulator, 1.8V, 1.5V Dropout, BIPolar, PSSO2

43034007,稳压器, LDO, 固定, 1.8V, 1.5A, -40 至 125度 C;

STMICROELECTRONICS LD1086DT18TR LINEAR VOLTAGE REGULATORS

STMicroelectronics LDO, 1.8 V, 1.5A, , DPAK, , 3

STMicroelectronics LD1086DT18TR 電圧レギュレータ

Low voltage differential Regulator (LDO)

LD1086 Tape & Reel (TR) Surface Mount Over Current Over Temperature voltage regulator linear 1.3V 2.4mm 1.5A -40C~125C

Ldo, Fixed, 1.8V, 1.5A, -40 To 125Deg C; Output Type:Fixed; Input Voltage Min:-; Input Voltage Max:30V; No. Of Outputs:1Outputs; Output Voltage - Nom:1.8V; Output Voltage Min:-; Output Voltage Max:-; Polarity:Positive Output Rohs Compliant: Yes |Stmicroelectronics LD1086DT18TR

The LD1086 is a LOW DROP Voltage Regulator able to provide up to 1.5A of output current. Dropout is guaranteed at a maximum of 1.2V at the maximum output current, decreasing at lower loads. The LD1086 is pin to pin compatible with the older 3-terminal adjustable regulators, but has better performances in term of drop and output tolerance. A 2.85V output version is suitable for SCSI-2 active termination. Unlike PNP regulators, where a part of the output current is wasted as quiescent current, the LD1086 quiescent current flows into the load, so increase efficiency. Only a 10uF minimum capacitor is need for stability. The device is supplied in TO-220, D2PAK, D 2PAK/A and DPAK. On chip trimming allows the regulator to reach a very tight output voltage tolerance, within +-1% at 25oC.