Vishay IL4108

IL4108 Series Single Channel 800 V 5300 Vrms Phototriac Optocoupler - DIP-6

OPTOCOUPLER, SCR, 5300VRMS; No. of Channels:1; Isolation Voltage:5.3kV; Optocoupler Output Type:Phototriac; Input Current:10mA; Output Voltage:800V; Opto Case Style:DIP; No. of Pins:6; Operating Temperature Max:100°C; Operating Temperature Min:-55°C; Operating Temperature Range:-55°C to +100°C

Optocoupler, Triac, 5300Vrms; Optocoupler Case Style:Dip; No. Of Pins:6Pins; Isolation Voltage:5.3Kv; Triac Operating Mode:Zero Crossing; Peak Repetitive Off State Voltage:800V; Product Range:-; Forward Voltage:1.35V Rohs Compliant: No |Vishay IL4108.

The IL410/ IL4108 consists of a Ga As IRLED optically coupled to a photosensitive zero crossing TRIAC network. The TRIAC consists of two inverse parallel connected monolithic Sc Rs. These three semiconductors are assembled in a six pin dual in-line package. High input sensitivity is ac hieved by using an emitter follower photo transistor and a cascaded SCR predriver resulting in an LED trigger current of less than 2.0 mA (DC). The IL410/ IL4108 uses two discrete Sc Rs resulting in a commutating dV/dt greater than 10 kV/ Ps. The use of a proprietary dV/dt clamp results in a static dV/ dt of greater than 10 kV/ Ps. This clamp circuit has a MOSFET that is enhanced when high dV/dt spikes occur between MT1 and MT2 of the TRIAC. When conducting, the FET clamps the base of the photo transistor, disabling the first stage SCR predriver. The zero cross line voltage detection circuit consists of two enhancement MOSFETS and a photo diode. The inhibit voltage of the network is determined by the enhancement voltage of the N-channel FET. The Pchannel FET is enabled by a photo current source that permits the FET to conduct the main voltage to gate on the N-channel FET. Once the main voltage can enable the N-channel, it clamps the base of the photo transistor, disabling the first stage SCR predriver. The 600/800 V blocking voltage permits control of off line voltages up to 240 VAC, with a safety factor of more than two, and is sufficient for as much as 380 VAC. The IL410/ IL4108 isolates low-voltage logic from 120, 240, and 380 VAC lines to control resistive, inductive, or capacitive lo ads including motors, solenoids, high current thyristors or TRIAC and relays.