onsemi FPF2165

Power Load Distribution Switch, High Side, 1 Output, 5.5 V, 800 mA, 0.12 ohm, MLP-6

FPF2164 Series 5.5 V 160 mOhm P-Ch Full Function Mosfet Load Switch - MLP-6

Full Function Load Switch with Adjustable Current Limit

High-end MICROFET-6, SMD, Adhesive Mount, 2mm × 5mm × 750μm

Power Supply Support Circuit, Adjustable, 1 Channel

Power Switch 0.15A 6-Pin MLP EP T/R

DFN-6(2x2) Power Distribution Switches ROHS

Load switch, Adjustable, 1 Channel, DSO6

POWER LOAD SW, HIGH SIDE, -40 TO 85DEG C;

IC PWR SWITCH P-CH 1:1 6MICROFET

IC LOAD SW FULL FUNCT ADJ 6MLP

The FPF2163, FPF2164, and FPF2165 is a series of load switches which provides full protection to systems and loads which may encounter large current conditions. These devices contain a 0.11Ω current-limited P-channel MOSFET which can operate over an input voltage range of 1.8-5.5V. Internally, current is prevented from flowing when the MOSFET is off and the output voltage is higher than the input voltage. Switch control is by a logic input (ON) capable of interfacing directly with low voltage control signals. Each part contains thermal shutdown protection which shuts off the switch to prevent damage to the part when a continuous over-current condition causes excessive heating. When the switch current reaches the current limit, the parts operate in a constant-current mode to prohibit excessive currents from causing damage. For the FPF2163 and FPF2164, if the constant current condition still persists after 30ms, these parts will shut off the switch and pull the fault signal pin (FLAGB) low. The FPF2163 has an auto-restart feature which will turn the switch on again after 450ms if the ON pin is still active. The FPF2164 does not have this auto-restart feature so the switch will remain off until the ON pin is cycled. The FPF2165 will not turn off after a current limit fault, but will rather remain in the constant current mode indefinitely. The minimum current limit is 150mA. These parts are available in a space-saving 6 pin 2X2 MLP package.